the labor times will be much less than Drive Shaft replacement.

Drive Shaft Boot Replacement #1

Detroit Axle - Brand New Complete Drive Shaft CV Joint Rebuild & Replacement Kit - Dodge Durango & Dakota 4x4 10-Year Warranty

  • Review
  • TAG : Toyota 4Runner CV Axle Drive Shaft Replacement
  • The next step is installing the replacement part. This involves sliding the new transmission carefully back into the transmission, making sure everything is aligned, and then bolting it in. Once all the bolts are tightened and it’s all securely in place, the drive shaft replacement is over – we just have to put the car back together.

    So in a nutshell, that’s how a drive shaft replacement happens on a car. At LG Engineering we can also do on trucks, mining trucks and equipment, marine vehicles, , performance vehicles and four wheel drives. !

  • Constant Velocity, CV, axles, are mainly used in front wheel drive vehicles though many modern rear wheel drive cars with independent rear suspension also use an axle kit. These parts assist in the turning of your wheel. CV axle replacement is generally done in tandem with drive shaft replacement.

    At Car Servicing and You our fully equipped workshop in Carnegie, next to Caulfield and Malvern East, provides CV joint and drive shaft replacement and repairs for all makes and models. All our car repairs come with a minimum 12 month/20000km warranty.

      Jeep Wrangler Forum > TJ Jeep Wrangler Forum > TJ General Discussion Forum

  •   Chevrolet Colorado & GMC Canyon Forum > 2004-2012 Chevrolet Colorado Forum / GMC Canyon Forum - First Generation Tech Area > Engines/Performance/Tech Questions > I4/I5 Engine & Drivetrain

    The innovative Drive Shaft Clamping Center Support (DSCCS) is the only true Permanent fix to bearing support failures. This Patented device was developed by our team of technicians whom over the course of 2 years were able to create what is now the end-all solution to failing Bearing Supports. The DSCCS is the ONLY device that can be installed without removing the Drive Shaft from the vehicle or without requiring the disassembly of the Drive Shaft. Why is this so important? 1) By not having to disassemble the Drive Shaft means that NO re-balancing of the shaft is required. All other methods of Bearing Support replacement require this expensive and lengthy procedure. Failure to balance the once disassembled Drive Shaft would result in major vibrations. 2) Our DDCCS installs easily to your Drive Shaft, using basic household tools, in less than an hour. This is a DIY repair that will save you costly repair bills and time down. If you choose to have a pro install it, the labor times will be much less than Drive Shaft replacement. The cause of the premature Drive Shaft Support failure is a direct result of too much continuous stress imposed upon the rubber in the mount. This is more the product of the Drive Shaft design than the quality of the rubber material in the mount. Unfortunately, by merely replacing the Bearing Support with another similar rubber mount you can expect much of the same results experienced with the factory rubber mount. There is only One certain and definite fix. The EPS DSCCS support takes a completely different approach in solving this problem. Getting away from the proven failure-prone solid rubber vibration dampener, we instead use multiple, hollow Silicone Pods. This design is much better equipped to withstand the constant compressing and stretching forces generated while in use. The silicone material also does a much better job of handling the heat and atmospheric conditions located under your vehicle.

2004 Ford F-150 Drive Shaft Replacement.